Hi all,
I loaded up the open source R3 schematics in eagle and had some boards made and have finally finished populating them. Unfortunately I am having trouble uploading any kind of sketch to the 328P-PU.
The bootloader was successfully installed on both 328P-PU chips. I have tried both the
Arduino-COMBINED-dfu-usbserial-atmega16u2-Uno-Rev3.hex and,
Arduino-usbserial-atmega16u2-Uno-Rev3.hex
firmwares for the MEGA16U2.
At this point i am unable to identify why neither board will receive a sketch.
Arduino IDE returns,
Binary sketch size: 1,082 bytes (of a 30,720 byte maximum)
avrdude: stk500_recv(): programmer is not responding
A loop-back test was conducted and the board successfully received the echoes.
Any help or insight would be appreciated.