I saw some tutorials with audio codec's but that need I2C (volume, mute control). I need only I2S because i want to use CS4334 Audio DAC.
USB Stack config "speaker demo" not working i mean that's my pc not see it. Then i program MCU i see LED on pin is pulsing, so program is not crashed.
When program have only SYSTEM_INIT() and SYSTEM_TASKS() in while loop, there's no effect.
I'm using PICkit3, the newest MPLAB X and Harmony.
I know some about PIC10...18F (I know how to configure 90% peripherals, interrupts etc) and I'm programming the micromouse robot. There im using PWM's, several timers, UART (Bluetooth module), I2C (Gyroscope) and ADC's (IR sensors).
Tomorrow I want to check USB CDC demo. I will send something with bluetooth module, maybe that can work.
I have only "UstekCAD" photo of schematic
:
https://imgur.com/a/NLREgI meant that robot micromouse is based on this same PIC32 microcontroller.