LVDS-eDP converter supply bypass

[nitrocaster]

Hi,
Is that really important for NCS8801 to have supply bypassed with 16 caps and 6 inductors as shown in typical application?
That would take a lot of space on the board, which is pretty much limited.
Any suggestions other than trial and error?
Datasheet is here.

[Rasz]

 I wouldnt skip caps, those decoupling pins are there for a reason.
you could probably skip inductors, most chinese and amateurs do when using IT6251 (similar chip) and it works fine
https://github.com/projectgus/novepad/raw/master/novepad-schematic.pdf
http://www.ebay.com/itm/LVDS-to-eDP-Signal-Conversion-Adapter-Board-For-LCD-Controller-Display-Panel-DIY-/161745320023
interestingly cheaper version appears to have better filtering on all rails
http://www.ebay.com/itm/LVDS-eDP-Converter-driver-board-f-LCD-screen-1lane-6bit-1366x768-fit-N156BGE-E41-/272186433444