PIC24F serial bootloader-P24QP "Run time error 53"

[muthukural001]

Hello All,

I am developing UART bootloader for PIC24FJ128GB206. I loaded bootloader code using pickit3. Then, I used P24QP serial programmer software application to load Applicatio program. Doing this, I was able to detect my MCU device id. But, when I try to write Application hex, I am getting "Run time error '53 '" and "File not found".

I don't know where to debug. It would be greatful if anyone suggest.



Thanks,
Muthu

[Howardlong]

Hello All,

I am developing UART bootloader for PIC24FJ128GB206. I loaded bootloader code using pickit3. Then, I used P24QP serial programmer software application to load Applicatio program. Doing this, I was able to detect my MCU device id. But, when I try to write Application hex, I am getting "Run time error '53 '" and "File not found".

I don't know where to debug. It would be greatful if anyone suggest.



Thanks,
Muthu

53 sounds like a raw doserror at your PC, rather than a debugger/programmer error.

ERROR_BAD_NETPATH
53 (0x35)
The network path was not found.