Hey there,
I am trying to update the firmware of an Galileo Gen 1 from 742 to 1.0.4 with the firmware upgrade tool.
Watching what happens on the serial port shows something strange>
6 BPS:[ 134.14978omm: clloade 3.8.7-yoc150096] Cal6] [<c107edrt_bad_irq+096] [<e077e_udc_isr+0x15d/0x1028 [40>] note_i60/0x1a0
55/0x130
[6] [<c107d6ercpu+0x70/34.150096] irq_event+0x 134.150096irq_event+06] [<c107f2q+0x70/0x70
e8bf1>] ? co6 ? do_IRQace_hardirq0x9a/0x170
[ 134.r_del+0xb/0xc1035ed5>] rq+0x55/0x130
[ 134.150096] [<c134.150096] <IRQ> [<c10360f5>] ? irq_exit+0RQ+0x43/0xb050096] [<c1trace_hardirqs_on_calle50096] [<c1x36
[ 134>] pch_udc_i]
[ 134.1bling IRQ #40
Byte 9] irq 40: nobody cared (try booting with the "irqpoll" option)
[ 134.150096] Pid: 875, cr Tainted: G W to-standard #1
[ 134.l Trace:
[ 134.1500974>] __repox24/0xc0
[ 134.15004ad>] ? pchpch_udc]
What does this mean?
How could I stop that interrupt popping up during my firmware upgrade?
Thanks a lot in case someone has an idea what is wrong.