Hello all,
I am trying to use Beetle DFR0282 to power a Bluetooth module and bunch of leds in my circuit.Now I want to make sure it can output enough current.The module operates at 5 V.
I am planning to use a 5 V voltage regulator between Beetle board and rest of my circuit.
I connected Vout and GND of Beetle DFR0282 to the bluetooth module Vin and GND to test but Beetle overheated and stopped working! OR In other word: BURNED!!
Now question is what circuit should i use in between to prevent this and supply enough current to the module.I am assuming a diode might help?
I appreciate any help!
Thanks!