Easy Nixie Counter to Clock Modification

[@rt]

Hi Guys

I should really say “Without” any modification

[Cliff Matthews]

Those 5's look about 100% better than the Rusky-tubes... Since it's only 12.5mhz, maybe the tube pin-out is compatible with the Elecrow PCB in this video:

[@rt]

There’s still the question of why I can’t reset it by pulling the reset signal to ground with a microcontroller pin.
I assume the DC SSR could be streamlined down to a transistor or bilateral switch, but an IO pin of the micro set low should be ground potential.