[N5B6] a. Output voltage greater than 6 V into a resistive load of less than 55 Ohms,
Hmm, so if you do it with AV cable (75 ohm), or you attenuate it enough, you're fine?
The direct output is quite 'hot' (about 100V for a 2N3904 avalanche), but that's almost useless for most applications as input voltage ranges tend to be quite small on sampling scopes.
Do they define how risetime must be measured? If I accidentally export a stack of 74LVC1G14 gates, am I screwed? If I measure with my Tek 475 and it says 2ns, who's to say I'm wrong? Are they going to crack open the crate, figure out how to power up and measure it, and ding me for it?
Tim