« previous next »
Pages: [1]   Go Down

Author Topic: Trying to identify a square keyed header connector  (Read 643 times)

0 Members and 1 Guest are viewing this topic.

Offline ezalysTopic starter

  • Frequent Contributor
  • **
  • Posts: 322
  • Country: us
Trying to identify a square keyed header connector
« on: September 19, 2018, 12:46:57 am »
Hey all,

I'm just trying to identify the mating connector for the attached keyed header connector. Has anyone seen one like this? I'm used to ribbon connectors having a single notch on one edge, but this has two shallow notches on one side and two deeper notches on the other. Perhaps I should just replace the connector? It it's 2x5 with 2 mm spacing.

Thanks everyone!
Evan
Logged
 

Online Monkeh

  • Super Contributor
  • ***
  • Posts: 7992
  • Country: gb
Re: Trying to identify a square keyed header connector
« Reply #1 on: September 19, 2018, 12:52:43 am »
JST PHD.
Logged
 

Offline ezalysTopic starter

  • Frequent Contributor
  • **
  • Posts: 322
  • Country: us
Re: Trying to identify a square keyed header connector
« Reply #2 on: September 19, 2018, 01:29:16 am »
Wow that was quick! Thanks! Do you have a suggestion for a budget-conscious crimper I could get to crimp the corresponding pins?
Logged
 

Online Monkeh

  • Super Contributor
  • ***
  • Posts: 7992
  • Country: gb
Re: Trying to identify a square keyed header connector
« Reply #3 on: September 19, 2018, 04:02:11 am »
Engineer PA..09, 20, 21? I can't recall which is which. Around the $40-50 mark iirc.
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee