Gentlemen,
I have finished the configuration software and I call the project ready to ship.
You can adjust output level from 50mV to about 1.2V peak-to-peak and flip the trigger/output phase in case you are using sampling scope. Not much of exciting science. Settings are non-volatile, stored in the device and survive power off.
There is a user calibration multiplier if you want to fudge voltage levels to read reasonably accurate value. Output matches indicated value to about 5-10%. Rise and fall times seems to stay the same throughout the whole output range (50-1200mVpp.)
I have 12 units in stock available here for shipping on Monday July the 17th: USB PulserThe next batch is coming on Wednesday so I am going to continue taking orders after the first 12 are gone. If you order does not ship on Monday, don't panic it's being assembled, tested, calibrated and shipped this week.
Many thanks for this fun!
Leo