I have indeed not used the mask editor at all yet. Could you describe what seems to be wrong? Ideally in a simple step-by-step sequence which we can try and reproduce.
- create a mask
- save the mask
- load the mask
- observe how the steps above have changed vertial scale, vertical position, andI can not reproduce this issue as yesterday, but it had changed vertial scale, vertical position and i belive the trigger level.
But instead i can deliver another issue (never mind as it might be fixed in the next version):
I have setup a qualified trigger that triggers just fine with 200mv/div, but changing to 100mv/div it does not trigger. The edge trigger does trigger on this signal down to 5mv.
I start wondering if my scope hase some issues itself, but then many of those were confirmed by others...