« previous next »
Pages: [1]   Go Down

Author Topic: Fluke 89IV no continuity beep  (Read 2011 times)

0 Members and 1 Guest are viewing this topic.

Offline wguibasTopic starter

  • Supporter
  • ****
  • Posts: 125
  • Country: us
Fluke 89IV no continuity beep
« on: February 02, 2016, 02:54:14 pm »
Picked up a used fluke 89IV and it seems to work except there is no continuity beep and the sound symbol on the display seems to be flickering very quickly.
Could the SMT-12 transducer be bad.  I'll have to check it when I get home tonight to see if there is any signal at the speaker.



Video of the flicker, tough to see on the video

https://wayneg.smugmug.com/Eevblog-/i-jJHG3xZ/0/960/20160202_094418-960.mp4
Logged
 

Offline ModemHead

  • Frequent Contributor
  • **
  • Posts: 731
  • Country: us
  • No user-serviceable parts inside.
    • Mr. ModemHead
Re: Fluke 89IV no continuity beep
« Reply #1 on: February 02, 2016, 04:53:42 pm »
Check the setup menu and make sure beep is turned on.  The slightly flickering beep annunciator is normal.
Logged
 

Offline wguibasTopic starter

  • Supporter
  • ****
  • Posts: 125
  • Country: us
Re: Fluke 89IV no continuity beep
« Reply #2 on: February 02, 2016, 08:23:45 pm »
Thank you, there was a setting for YES/NO for beep.  It now beeps, funny they show the sound icon if it's disabled.
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee