So my first oscilloscope arrived today. Before leaving for work, I had a quick look under the hood. I didn't spot any obvious damage (bulging/leaky caps, cut/damaged cables, etc. I plugged it in, hit the power button, and waited a few minutes for it to warm up. It has power. The light is on. No green line after several minutes. I plugged the probe in, switched on Ch. 1, and hooked the probe up to the calibration tab. No square wave. Nothing at all. I'm hoping I just didn't have a switch in the right position. Step 1 is to download the manual tomorrow. I'm currently at work so I'll be unable to provide instant feedback, but suggestions are welcome. I've had some limited experience with the digital oscilloscopes at school, but this is quite different . Be gentle. I'm a noob.
Sent from my SM-G900V using Tapatalk