The PS is a Tagan (480W if I remember correctly) - I will check the model later, it's not in front of me at the moment. The fuse burnt, I open it up, and see a couple of low voltage cap + one of the 200V caps with the lead slightly bent. I assumed they were all fried. Took them out of the circuit, measured them (with both the DMM, and by putting a voltage on them) and they work fine.
Kept on searching, found 2 transistors (2SC3320) which are shorted. Next to them is a PFF6N60 which has a diode between two pins, and an open circuit to the 3rd pin.
So the questions at the moment are:
1 - Is there anything else I should check? The rectifier is mounted on a small PCB next to it and it check fine.
2 - What replacement transistors would you recommend for the 2SC3320?
3 - I could not find the datasheet for the PFF6N60. I found some data sheet with the same part number but it isn't the same part. This one is in a TO-220 package, and the one I found is actually for some sort of DO-XX package. Can someone tell me what this part is, and what commonly available part I can use in its place?
Thank you.