HP 8594E ntsc setting

[Daxxin]

Swapped the crt from an 8593 that supports only ntsc my configuration is set to NRM PAL i view only garbled things
someone has this scope can pls post picture about CONFIG steps to push correct buttons until i can restore NTSC.

thanks

[MarkL]

This is from an 8495E, but it should be the same:

First, press the CONFIG button.
Then, press side button #6 twice to get to the SYNC menu.

Then:

Press side button #2 to toggle between NRM and NTSC
  -or-
Press side button #3 for DEFAULT SYNC
  -or-
Press side button #4 to toggle between NRM and PAL

You could also try plugging a monitor into the back to see what you're doing.

[Daxxin]

Thanks it works , i tried to make VI in labview to do that but unsuccesfil