Author Topic: IR3500 Output not working  (Read 586 times)

0 Members and 1 Guest are viewing this topic.

Offline ColdwoveTopic starter

  • Newbie
  • Posts: 1
  • Country: au
IR3500 Output not working
« on: March 23, 2018, 05:18:11 pm »
Hi,

I'm trying to get a VRM board to power up outside of it's enclosure so it can be reused for other purposes. The main control chip is an IR3500 and I am having problems getting the chip to fully enable. I have sent an enable signal to the pin, wired the feedback and biased the VRHOT and VRRDY pins as well as set up the VID and VIDSEL, however upon power up all I am getting is 0.18V on the output. Any ideas as to why the chip isn't fully starting up would be greatly appreciated.

Cheers.
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf