Crest Ultrasonics Drain Valve

[dfnr2]

Low tech question here.

I picked up a Crest Ultrasonics 2600HT benchtop ultrasonic cleaner, and it's missing the valve on the back that keeps the tank from draining out.  Does anyone have any info on this valve?  I think it's a 5/8" threaded connection on the back, but can someone confirm?  Any suggestions on a replacement valve?

Thanks!

Dave

[aargee]

If you're unsuccessful then try this... on my US cleaner there is a latex drain tube and a clip to keep it above the level of the tank.

When you're ready to drain, just let the tube drop down into the drain.

[james_s]

Do you have a real hardware store anywhere near by? Not like Home Depot but one of the little places that has actual hardware? That or a specialist plumbing supply place, you could take the cleaner there and probably find something that will work.

[Psi]

Ask Louis Rossman if he can order you one.
He has become a supplier of Crest ultrasonic cleansers

[DTJ]

If the hole is about 16mm, roughly 5/8" then it could be a 3/8" 19 TPI BSP/T pipe thread - your local hardware should have a ball valve for $5 or $10.