« previous next »
Pages: [1]   Go Down

Author Topic: Mains wiring question  (Read 1733 times)

0 Members and 1 Guest are viewing this topic.

Offline radhazTopic starter

  • Regular Contributor
  • *
  • Posts: 213
  • Country: us
Mains wiring question
« on: September 28, 2014, 07:15:19 pm »
I'm working on a Jung Jin 1051B RF signal generator that appears to be dead.
I've got the power supply out, and measuring the voltages, things appear off.
It looks like the unit might be wired incorrectly for the 120 vac for my area. Thoughts?
I should add that these values are with the loads disconnected. With the loads, there is sag of the DC voltages.
« Last Edit: September 28, 2014, 07:19:53 pm by radhaz »
Logged
 

Offline radhazTopic starter

  • Regular Contributor
  • *
  • Posts: 213
  • Country: us
Re: Mains wiring question
« Reply #1 on: September 28, 2014, 08:12:04 pm »
Issue solved. This unit has a Corcom J series input module with a small PC card to select the input voltage. It was set to 220 vac. Set it to 120 vac and I have front panel lights. :-DD

In case anyone runs into a similar issue:
http://www.mouser.com/ds/2/418/J-12416.pdf
« Last Edit: September 28, 2014, 08:13:49 pm by radhaz »
Logged
 
Pages: [1]   Go Up
« previous next »

Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf

 


EEVblog Main Site EEVblog on Youtube EEVblog on Twitter EEVblog on Facebook EEVblog on Odysee