Part identification: Worn down switch

[thf]

Greetings

The hood in my kitchen is failing me, its the on/off switch that's worn down. I'm usually the parts procurer/finder at my job, but my searches come up blank.

I hope someone knows the markings on the switch.

Thanks in advance

[Armadillo]

Pry Open it up from the plastic slot slowly and clean the contacts with deoxit.

[Neomys Sapiens]

Manufacturer is either Schadow or Schurter

[Gyro]

Pry Open it up from the plastic slot slowly and clean the contacts with deoxit.

It's unlikely that a mains switch is suffering from contact oxidation, more likely is that the contacts or mechanism are worn out. A worn and arcing mains switch is a fire hazard.

[thf]

Hi all

Thanks for the inputs! Didn't think to clean the contacts. However the wifu managed to kill it completely today, and that left a skid-marks on the PCB.. It was a bad solder on one of the pins! So a bit of solder managed to salvage the hood.

What a crappy circuit design they made though.. All wires a connected on a single board with spade connections..

Thanks again!