Electronics > Repair
PC Power Supply
vidarr:
This Thermaltake PSU was brand new. It has a warranty, but circumstances (where I live now) prevent me from being able to use it. I fired this thing up maybe 4-5 times. The last time, it popped, sparks came out and then smoke came out. After a year of trying to get the warranty coverage with no luck, I decided to just open it and have a look. I was hoping it was the fuse or something simple. The fuse was fine, but I put a new one in anyway. I inspected everything visually and cannot find anything obvious. The only thing odd is maybe a transformer that looks like it is bulging out (see pic).
I checked connections from the plug to the fuse with a DMM and there is continuity between connections. Should I take out the main board and inspect the bottom next?
edit: It is Thermaltake Toughpower Grand.
tpowell1830:
What looks like a transformer in the first pic looks like the magic smoke got out and all over the top, as it looks kind of smokey. As far as looking all over, it is a good plan if you want to try and repair, but if transformer is blown, there is no telling what else it could have taken with it.
GeoffreyF:
I agree tpowell1830 ... it looks like something catastrophic happened. If the mains in your country doesn't match the specifications or switch settings on the back, that could be the genesis of the failure.
PKTKS:
Some words of care first..
- Don't put your DMM randomly in such devices - there are high voltages spikes
and even powered down CAPACITORS WILL HOLD THE CHARGE (for a long period)
- Don't power such HIGH POWER device without an ISOLATION TRANSFORMER **AND**
a REQUIRED VARIAC to start looking suspects.
- Worst case scenario you REMOVE ALL DIODES (which is very time consuming) from the board
and the transistors to properly check them OUT OF CIRCUIT (no voltages no parasitics)
The procedures are not trivial - and VOLTAGES are really dangerous when powered on.
Take care of yourself and your bench first...
Paul
vidarr:
The white stuff all over the components is that insulation, glue stuff. Is that what you are looking at? I took some better pics of that. When the white spirit came out it didn't go far. It just hovered by the side of the PSU. I don't think it went to Valhalla. But it was kind of dark in the room, so not sure.
As for safety, thank you for the reminder. I know about a kid who died working on his PSU and that scares me (I think he shorted a capacitor). I only worked around the plug and fuse so far. The PSU has been sitting un-powered for about three years now. If I take the main board out, I am going to watch as many tutorials I can find first. I got tagged by a capacitor when handling salvaged stuff and it hurt like a hot knife stab. Now, I am borderline paranoid.
BTW, did any of you ever see the video of the Chinese kid who was at one of those Chinese internet cafes. He had is phone charger plugged into a 220V outlet. He was moving something around and he stuck the other end of the cord in his mouth. About 2-3 seconds later, the saliva seeped in, and he went from a sitting position to straight as a board in a millisecond. Then, his eyes started lighting up like halogen bulbs. He looked like a X-men character.
Thank You!
Navigation
[0] Message Index
[#] Next page
Go to full version