PSU Tektronix PS 2510G

[SteF]

Hello friends,

I recently bought a Tektronix PS 2510G PSU;
it delivers 3.5A from 0 to 36V, but fails to go beyond 28V;
when I try to activate the load with a voltage higher than 28V appears error 013 on the display, it seems to be a problem to one of the relays ...

does anyone have the scheme of this power supply available?

Thx
SteF

[siggi]

when I try to activate the load with a voltage higher than 28V appears error 013 on the display, it seems to be a problem to one of the relays ...

I believe error 13 is when the over voltage protection trips. Sounds like the OVP is set for 28V, have you tried increasing it?


Sent from my iPad using Tapatalk

[SteF]

Hello,

yes

I checked it … the OVP is set for 35V
It seems like a problem with one of the three relays …

SteF