Small mains socket (case mounted) and plug recommendation

[owiecc]

Do you have any recommendations for a small plug/socket 230V rated. I will use it on a blade saw. One of the adapters needs 230V and is now connected to a wall socket. I was thinking on replacing that and taking the power from a saw unit. Current drawn by the adapter is extremely small, well below 1A.

The saw is quite small and I would like to put a small socket on its case. There is also water involved in the cutting so ideally the socket should be splash resistant. Do you have any recommendations? I found a few already but they were either huge 16A rated or super expensive.

[wagon]

Something like this http://au.element14.com/amphenol-tuchel/c016-20c003-200-12/plug-panel-screw-au-3p-e-way/dp/1188985

I've used them for similar jobs with success.

[Psi]

As long as that one is for mains input 

[dom0]

Hirschmann ST series? 2+PE is available and suitable for mains.

[wagon]

As long as that one is for mains input 

They are rated to 250V.  Don't know about 'approval', however.