I am trying to help a friend to troubleshoot a non starting Stahlwek (china made) WIG200p
It was working last summer but my friend stored it out on his porch but it has both windows and
roof, i nailed it down so far yet that the powersupply does not start up (in the schematic) Q101
gets fed thru C103 and D107? shall this give the gate a positive voltage pulse around 8-9V on the
gate on the mosfet? It was dead until my friend touched the gate of the mosfet Q101 with his multimeter
Does this circuit make sense to anyone else?
Am i wrong with that the 8.2V zener shall get some voltage thru these: C103/D107/R210 ?
Can't find anything else C103 is measured at 9.9nF ERS 18ohm all electrolytes seems ok
he even checked the diodes in the circuit (1n4148)
Something is wrong i say lol!