I've got an older PowerMax alarm, used for a couple of years, but moved to a new location where there was a security system allready, so it had been put to sleep in 5-6 years. However, now i have a use for it, and decided to power it up. Changed a 1000 uf cap, as it was bulging and the alarm runs well now.
But i can't remember the installer code. A look in the manual says to power it up with a jumper on the RESET pins, but it does not seem to do anything, other than default the system volume, etc. My two remote controls still works, even after a reset.
Anyone have a clue, where to start?
I've attached an overview picture, if needed I can take more shots. The two PIC's are Microchip PIC17C756A.
There is a RS232 header, and a PROG header. Is there any chance to get in that way?