I asked smallsmt a few days ago about his machines.
And if there was a place where I could buy them in china since I am located there.
No response yet. I'm not going to gamble like 3K on that.
The machines with ballscrews seem very stable and the feeder system seems to work good.
The visionplacer 3000 software (should also support VP2500 VP2800) is even better for small BGA work (detects the balls) etc.
The VP3000 seems like a winner but if it's really produced in germany than the price will be to high to be competitieve in china
due to the import cost. or they must have a good distributor here.
I have asked about this but like I said no response.