Dear Friends,
I am pleased to be part of this forum. Advance I apologize for my not good English.
I have two soldering station of ERSA I-Con 1 and expect to receive ERSA EASY ARM 110i (solder fume extraction systems). The extraction system have remote control but is compatible only with ERSA I-CON C soldering station. I check in Internet that the difference between I-CON 1 and I-CON 1 C is only this remote control port for extraction system (one DB9 port of the back side of the soldering station).
I want to ask you if any of you have I-CON 1 or 2 C soldering station with remote control port to send more information about it. Cable circuit and pictures of the PCB. I want to make my I-CON 1 with remote control port and I think that the PCB's are the same but I do not know where I can connect this DB9 remote control port and the pinout of the DB9. In the worst case I might have to reflash the ATMEGA.
Thank you in advance for the help Friends!
Best Regards,