Author Topic: JBC MS-A desoldering pump  (Read 253 times)

0 Members and 1 Guest are viewing this topic.

Offline chamod

  • Contributor
  • Posts: 20
  • Country: nz
JBC MS-A desoldering pump
« on: December 06, 2018, 08:52:52 am »
We have a set of of JBC tools at work, including a DDE (2 tool module), hot air station and a pre heater. We also have a MS-A desoldering pump, but no associated DI(single tool ) control module.
 Would there be any way to get the MS-A working without spending 500$ on DI control module? We already have a slot free on the two tool controller DE, and I think functionally DDE is very close to two DI modules.

DI: https://www.jbctools.com/di-1-tool-control-unit-product-155-gama-6-category-6.html
DDE: https://www.jbctools.com/dde-2-tools-control-unit-product-919-gama-6-category-6.html
MS-A: https://www.jbctools.com/ms-a-electric-desoldering-module-for-di-product-160-gama-6-category-6.html
 

Offline RobertHolcombe

  • Frequent Contributor
  • **
  • Posts: 253
  • Country: au
Re: JBC MS-A desoldering pump
« Reply #1 on: December 06, 2018, 02:49:23 pm »
Don't see why you would need anything more than the desoldering tool and associated stand

DI/DDE/DME all do the same thing just have more ports, MSA attaches to any control unit, then the tool and stand connect to the MSA
 

Offline chamod

  • Contributor
  • Posts: 20
  • Country: nz
Re: JBC MS-A desoldering pump
« Reply #2 on: December 06, 2018, 03:24:43 pm »
I managed to get the tool to heat up, but I don't have a port to provide power to the MSA pump module. DDE peripheral port is different from that of the MSA. I have attached the photos of the backs of the units.
 

Offline RobertHolcombe

  • Frequent Contributor
  • **
  • Posts: 253
  • Country: au
Re: JBC MS-A desoldering pump
« Reply #3 on: December 06, 2018, 04:46:41 pm »
Yeah right, I just checked, seems odd but there is a MS-A and MSE-A, the later is compatible with DDE/DME

Guess that compatibility change occurred when they shifted the multi tool control units to the new type display
 

Offline chamod

  • Contributor
  • Posts: 20
  • Country: nz
Re: JBC MS-A desoldering pump
« Reply #4 on: December 07, 2018, 08:15:13 am »
Yeah that looks like the reason. I couldn't find any information about their connectors/pinouts either. Looks like that MSA is going to  go back to the drawer. :-//
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf