I've had one without a TG and it is a nice unit, but the sweep speed performance of a benchtop SA is way different from a handheld. I believe the cap is 10 sweeps per second on the MS2721B with current firmware, and I believe the default full span sweep time is something like 1.5 seconds. Compare this to a benchtop unit and there is no comparison... you can expect 2-3 times the maximum update rate and probably a quarter or less time per sweep in most cases. The buttons always respond (no missed inputs), but when the sweep time is long it can take extra time for the buttons respond.
At one point I contacted Anritsu for a replacement part and they were actually quite friendly to work with, I was buying a replacement kickstand and the rep I spoke with called me back and said they found a used one lying around and sent it to me for free. They were also willing to sell software options for it, still, but I believe they were full launch price, so hardly worth it when buying secondhand and an option or two would be 50% of the total price.
Great for making measurements, good low noise performance, smaller footprint and portable anywhere, but much slower overall to work with, as I think probably goes with most handheld units. I found that most of my work was at the desk and was sort of scanning around for stuff, so I swapped over to a benchtop unit and enjoy having the extra update rate.