Do you recognize this connector? Chauvin Arnaux E14 Current probe

[diegoperez]

After searching for a while, I could not find any information about this current probe.

It is very similar to the ubiquitous chauvin arnoux E3N current probe, which I think is rebadged under various other brand names.
But this one does not have the dc-offset trim pot nor the over-range led indicator. In addition, I think this current probe needs a terminating resistor at the connector end, because the gain seems to be wrong when connected to a 1-MOhm scope input impedance.

Any info regarding the connector or the probe will be welcomed.

Thanks,

Diego

[0xfede]

Hi Diego,

it seems to me a lemo connector.
Have a look to their site:
https://www.lemo.com/en

Best,
0xfede

[vtp]

Try Hypertronics D-series, possibly D02.

[diegoperez]

Try Hypertronics D-series, possibly D02.

Wow, that's right. It's a D01 series with 3 contacts (but only two are populated).
After comparing the dimensions whith the catalogue, I also noticed a 'D01' engraving mark in the connector  , which further confirms it.

Thank you! 

[angeeinstein]

Did you get this probe to work?

[shakalnokturn]

This also seems to be the same connector I was inquiring about in this topic:
https://www.eevblog.com/forum/testgear/dossena-multiver-3-sn-3-phase-network-analyser/msg5096883