Hi
Does anybody have any information how to calibrate an Extech 470 multimeter? Especially the 400 mA current measurement range?
Or does anybode have a service manual with calibration procedure?
The device really has
many potentionmeters! I count 16; VR1 to VR16.
I've had to replace the 500 mA fuse as well as resistor R13 (99 Ohm, 0,5% tolerance) because I made a short circuit during AC measurement (in the 400 mA range). If I replace the resistor, I think I have to re-calibrate this range.
I would be grateful for every help.
Regards
Roman