Low Cost PCB's Low Cost Components

Author Topic: [Ersa i-Con PICO] Using soldering iron with own DIY station  (Read 1532 times)

0 Members and 1 Guest are viewing this topic.

Offline ivandevel

  • Newbie
  • Posts: 3
[Ersa i-Con PICO] Using soldering iron with own DIY station
« on: October 13, 2014, 05:10:13 PM »
Hello! I've bought a new i-Con PICO soldering iron, it's awesome! I want to make my own PID station for this solder. I have discovered a pinout (in attachment) Can anyone, who have this station, make a probe with oscilloscope or logic analyser between green and yellow wires? I think that there is an one-wire IC embedded in soldering iron ... A heater module of this iron consists of a termocouple and a ceramic iron.
« Last Edit: October 13, 2014, 05:13:36 PM by ivandevel »
 

Offline ivandevel

  • Newbie
  • Posts: 3
Re: [Ersa i-Con PICO] Using soldering iron with own DIY station
« Reply #1 on: October 17, 2014, 04:01:55 AM »
up
 

Offline Creep

  • Regular Contributor
  • *
  • Posts: 80
  • Country: lv
Re: [Ersa i-Con PICO] Using soldering iron with own DIY station
« Reply #2 on: October 17, 2014, 04:29:47 AM »
Going a little off the topic but:
Where did you buy the iron itself? I have the station but the heating element on my iron seems to have died...
 

Offline Yago

  • Frequent Contributor
  • **
  • Posts: 651
  • Country: gb
Re: [Ersa i-Con PICO] Using soldering iron with own DIY station
« Reply #3 on: October 17, 2014, 04:34:56 AM »
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf