Hi folks!
I found document "Instrument Security Procedures for Fluke 9x Series ScopeMeter" which says - The operating code (instrument firmware) stored in D101-D102 on the A201 module can be read using special remote interface commands. Calibration constants stored in D101-D102 on the A201 module can be read using special remote interface commands.
May be someone knows these two special remote interface commands? I need to save both:instrument firmware and calibration constants from my Fluke 97.
Thanks.
http://assets.fluke.com/manuals/93_95_97mveng0000.PDFThanks
Regards