Author Topic: lecroy scope remote control, missing commands  (Read 667 times)

0 Members and 1 Guest are viewing this topic.

Offline aguevelTopic starter

  • Newbie
  • Posts: 1
  • Country: fr
lecroy scope remote control, missing commands
« on: June 05, 2018, 08:35:15 am »
Hi everyone !

I'm currently using a lecroy WaveRunner6030 oscilloscope in remote control mode. It's working quite good with most of the commands I found in the remote control manual, but I met a few issues :
- Multi-Zoom command does not work
- I could not fin any command to switch a trace from a grid to another (equivalent of next grid button) in dual grid mode for example
- Also met issues with zoom parameters command : HMAG, HPOS ... not understood by the scope

Thanks if you have any informations about these !
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf