EEVblog Electronics Community Forum
Products => Test Equipment => Topic started by: jotrinelectronics on August 02, 2018, 07:50:15 am
-
First find the corresponding product specification to determine the product pin and the range of parameters to be measured, and adjust the plotter to measure. The specific turn-on voltage curve and the reverse withstand voltage curve are as follows.
BUT I DONT SURE IF IT IS RIGHT
Turn on the voltage curve:
(https://www.jotrin.com/Userfiles/image/20180719/20180719120825_0820.png)
Reverse pressure curve:
(https://www.jotrin.com/Userfiles/image/20180719/20180719120905_5797.png)