EEVblog Electronics Community Forum

Products => Test Equipment => Topic started by: AlanR on January 20, 2016, 05:37:53 am

Title: Rigol DP832A Rev 2.1 Help.
Post by: AlanR on January 20, 2016, 05:37:53 am

I somehow blew out channel one's fuse and pass mosfet when I accidentally shorted a brushed DC motor's wires together that was connected to the power supply. The other 0-30  volt channel worked and the 5 volt channel still worked, but now after I did the repair to channel one I get this error: "Analog Board self-test Fails!". Channel one now works again, but channel two and the 5 volt channel no longer work. Does it need calibration or something?




DOH!!!!!!!!!!!!!!!! I found that I forgot to connect a header pin that sits on the side of the frame chassis of the power supply.  |O |O |O |O It now works again without error.

Title: Re: Rigol DP832A Rev 2.1 Help.
Post by: _Wim_ on January 20, 2016, 07:06:40 pm

Been there, done that. Good to hear it works again!