EEVblog Electronics Community Forum
Products => Test Equipment => Topic started by: oldprogrammer on September 15, 2016, 02:28:07 am
-
see pics here - http://imgur.com/a/6EOxj (http://imgur.com/a/6EOxj) When I set the decode options to display data in ASCII (bottom pic with all EEEE), the bytes are shown correctly. When I set to display in Hex, byte frames are blank. Anyone run into this? Thanks!
-
There might not be enough space in the little box for the HEX representation. Speed up your Time/div to display fewer but wider boxes.