EEVblog Electronics Community Forum

Products => Test Equipment => Topic started by: bd139 on October 06, 2018, 04:17:21 pm

Title: R&S SMG / SMH RF signal generator N-type output connector replacement
Post by: bd139 on October 06, 2018, 04:17:21 pm
Seen a couple of these floating around for reasonable money but the N type connectors may have been dinked badly. The BNCs are a write off. Does anyone know if they are connected directly to the attenuators on the output or via hard line etc? Trying to work out if it’s even worth buying one as a repair project.

I have the full service manual but no pictures of the construction.