EEVblog Electronics Community Forum
Products => Test Equipment => Topic started by: zanzeoo on January 08, 2016, 05:56:50 am
-
Hi every ! I've just bougnt the new RIGOL DS1074Z S PLUS , I tried the unlock keygen tool but none keys seem to work
Software version is 00.04.03.SP1
Board 6.1.1
Does anyone can help me ?
thx !
-
I highly doubt the new Plus models are supported by any key gen(but hope I am wrong).
-
me too ....
-
Are these not MSO upgradeable? In which case, maybe the MSO1000Z procedure is needed.
-
Are these not MSO upgradeable? In which case, maybe the MSO1000Z procedure is needed.
I think you might be on to something.
zanzeoo check out this thread:
https://www.eevblog.com/forum/testgear/sniffing-the-rigol's-internal-i2c-bus/msg569236/#msg569236 (https://www.eevblog.com/forum/testgear/sniffing-the-rigol's-internal-i2c-bus/msg569236/#msg569236)
-
Any luck with this one?
-
Are these not MSO upgradeable? In which case, maybe the MSO1000Z procedure is needed.
I think you might be on to something.
zanzeoo check out this thread:
https://www.eevblog.com/forum/testgear/sniffing-the-rigol's-internal-i2c-bus/msg569236/#msg569236 (https://www.eevblog.com/forum/testgear/sniffing-the-rigol's-internal-i2c-bus/msg569236/#msg569236)
I completed the procedure outlined in that thread on my DS1074Z-S Plus and can confirm it works.
-
Logic probe are passive wire?
Can I make it myself an unlock logic analyzer?
-
Logic probe are passive wire?
Can I make it myself an unlock logic analyzer?
See my post here:
https://www.eevblog.com/forum/testgear/why-are-siglent-channel-logic-module-adaptors-so-expensive/msg1123705/#msg1123705 (https://www.eevblog.com/forum/testgear/why-are-siglent-channel-logic-module-adaptors-so-expensive/msg1123705/#msg1123705)
-
Ok
But without the logic probe, does it work?
Connecting the wires to the connector directly?
Those comparators increase the efficiency, but for most applications, slower, could fit the same.
It 'a commercially available connector?
-
Ok
But without the logic probe, does it work?
Connecting the wires to the connector directly?
Those comparators increase the efficiency, but for most applications, slower, could fit the same.
It 'a commercially available connector?
It's a high density connector, without measuring it I'd say 0.05" pitch. This is because the signals between the pod comparators and the scope are differential, so you'd need to deal with that aspect as well as any amplitude and CM adjustment.
I am sure you could cobble something together, whether you'd want to though is another matter!
-
Hi
Thx you but i think the link is dead... :(
-
The link doesn't work because of the apostrophe character in the URL.
Replace it with an underscore: https://www.eevblog.com/forum/testgear/sniffing-the-rigol_s-internal-i2c-bus/msg569236/#msg569236 (https://www.eevblog.com/forum/testgear/sniffing-the-rigol_s-internal-i2c-bus/msg569236/#msg569236)
(note the link is spelled now with "rigol_s" instead of "rigol's")