EEVblog #952 – Nixie Tube Display Project – Part 3

More on the nixe tube driver chip, testing for bias glow and clamp voltages.
Schematic design in Altium Designer.
Selection of the Wifi ESP8266 module
Traps in 3.3V / 5V logic level translation.
Design tip for neat schematics.

Forum HERE

About EEVblog

Check Also

EEVblog #1334 – Mystery Dumpster Teardown

Mystery dumpster teardown time! With the most amazing mechanical mains power switch you’ll ever see! ...

4 comments

  1. The download link doesn’t seem right. It is currently ends in “EEVblog953-SchematicERC-640×360.m4v”, not something with 952 and perhaps containing “nixie tube display” and “part 3”.

Leave a Reply

Your email address will not be published. Required fields are marked *