EEVblog #1327 – 3 Ways to FAIL at PCB Manufacture

EEVblog August 9, 2020 Design & Build, EEVblog, PCB Design & Manufacture Comments Off on EEVblog #1327 – 3 Ways to FAIL at PCB Manufacture 17,545 Views

Three ways to get your PCB design rejected by your PCB manufacturer. 1) Imperial/Metric conversion 2) Unexpected Trace/Space specifications 3) Goofing the Gerber resolution.

Forum: https://www.eevblog.com/forum/blog/eevblog-1327-3-ways-to-fail-at-pcb-manufacture/

Podcast: Download

About EEVblog

Check Also

EEVblog 1652 – Why is my Lab Switchboard Wired Like This?

Why is my lab power switchboard wired like this? Forum: https://www.eevblog.com/forum/blog/eevblog-1652-why-is-my-lab-switchboard-wired-like-this/ Podcast: Download

About
© Copyright 2024 David L. Jones. EEVBlog is a registered trademark.