Products > 3D printing

Advice for USB dongle enclosure

<< < (3/3)

Kosmic:

--- Quote from: Mechatrommer on March 27, 2024, 11:01:22 pm ---i will avoid PLA any days, it will disintegrate in a matter of 3-5 years.

--- End quote ---

When used inside, I never seen PLA change that much over time. I even tested with a high resistance meter and years old PLA parts still measure in the POhm range.

Might be the quality of the PLA used or a drastic difference in environmental condition? The printer might also be the cause.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod