Off Topic Hobbies > 3D printing

Anet A8 Door Hinge Upgrade

(1/1)

bostonman:
Has anyone done this upgrade?

It looks quite useful, however, I question the heatsink not being completely mounted to the extruder.

I'm guessing the heatsink doesn't do much since it's not mounted tightly. My guess: it's used to prevent the air from blowing directly into the extruder and not necessarily for cooling.

The door hinge upgrade looks useful, but, as I stated, the heatsink basically rests against the extruder. If it's meant to draw heat away from the extruder, it seems this will cause less thermal conduction.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version