Products > 3D printing

Bed heating and avoiding PLA warping

<< < (5/5)

mikerj:
I had a nightmare with parts warping and lifting off the bed in the corners until I realised it was a draft caused by the open fireplace in the room.  PETG was the worst for this but PLA also did it, some brands worse than others.  I have a partial enclosure around the machine now to shield it and that completely stopped the problem.

I've not had too many issues with the soft textured build surfaces, but my textured PEI build surfaces requires fairly regular scrubbing with dish soap and a pan scrubber to make prints stick well.

Navigation

[0] Message Index

[*] Previous page