Products > 3D printing

Doubt in Support - CURA

<< < (3/3)

SKY KALAI:
I didn't use tree support yet. I will test by today with tree support.
Thanks

thm_w:
You may have some significant over extrusion and warping.
Have you calibrated the printer yet, specifically the flow rate?

https://teachingtechyt.github.io/calibration.html#flow
https://teachingtechyt.github.io/calibration.html#esteps

SKY KALAI:
Not now. I calibrated it long time ago. I will do it once again. I will go through your links, thanks for helping me.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version