Products > 3D printing

Getting a new 3D printer, my there are so many

<< < (12/12)

CatalinaWOW:

--- Quote from: abeyer on December 05, 2023, 02:33:39 am ---
--- Quote from: MarkF on November 22, 2023, 12:30:16 am ---I'm not sure how I feel about a web based printer controller.  I'm usually not big on web-based anything.

--- End quote ---

I believe you can basically ignore most of the web part if you don't care to use it. The bigger change in Klipper is the offloading of more of the motion control computation to the cpu in the pi rather than the micro in the printer... and that part isn't really tied to any of the web ui stuff.

--- End quote ---

You can completely ignore the web part, setting it to  use only the LAN, or even just using microSD to transfer files. 

MarkF:
Thanks for the Klipper comments.

Anyone have any thoughts or experience with the Elegoo printers?

Lindley:

--- Quote from: MarkF on December 05, 2023, 07:29:34 am ---

Anyone have any thoughts or experience with the Elegoo printers?

--- End quote ---


Have you seen this and the several other Elegoo posts on the Reddit forum ?

https://www.reddit.com/r/ElegooNeptune3/comments/14379se/neptune_3_pro_vs_neptune_4_pro/

MarkF:

--- Quote from: Lindley on December 06, 2023, 09:00:58 pm ---
--- Quote from: MarkF on December 05, 2023, 07:29:34 am ---

Anyone have any thoughts or experience with the Elegoo printers?

--- End quote ---


Have you seen this and the several other Elegoo posts on the Reddit forum ?

https://www.reddit.com/r/ElegooNeptune3/comments/14379se/neptune_3_pro_vs_neptune_4_pro/

--- End quote ---

No, I hadn't seen them.   Thanks.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod