Products > 3D printing

Input shaping now in Marlin


For those on the bleeding edge, of Marlin, experimental input shaping has been added:

If you have an issue with ringing in your print, and want to print faster, might be worth looking at.
Its a manual calibration process, so you print a test piece, and measure the X and Y resonant frequencies on the print, then enter those in the config. AFAIK.

Personally I just print a bit slower, but I also don't use a bed slinger.


[0] Message Index

There was an error while thanking
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod