Products > 3D printing

Low cost ($3K) SLS printer announced

(1/2) > >>

mikeselectricstuff:
 

coppercone2:
not to excited about dealing with powders. I feel like I will be trolled by that process.

Jackster:
If they can deliver, that is a nice price for what you are getting even with only a build volume of "145 x 145 x 200 mm".

Psi:
I wonder what the print time is like

mikeselectricstuff:

--- Quote from: Psi on April 07, 2024, 10:57:07 am ---I wonder what the print time is like

--- End quote ---

Probably quite slow for single parts, but can print a lot of parts in one go, so maybe better for small-run use than prototyping.
 

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod