EEVblog Electronics Community Forum

Products => 3D printing => Topic started by: HobGoblyn on September 20, 2021, 10:31:34 am

Title: My CR10 V2 is now all in one and direct drive :)
Post by: HobGoblyn on September 20, 2021, 10:31:34 am
My CR10 V2 is now all in one and direct drive  (thanks to this thingyverse project https://www.thingiverse.com/thing:4347673 (https://www.thingiverse.com/thing:4347673))


See pics below, I ran out of red for the last bit, hence printed in grey :)

As I have a spare stepper driver on the SKR 1.4 Turbo, now have each z axis motor on their own hence have enabled Z stepper Auto Align

Everything took much much longer than I anticipated (as usual) but pleased with the result :)