Off Topic Hobbies > 3D printing

My CR10 V2 is now all in one and direct drive :)

(1/1)

HobGoblyn:
My CR10 V2 is now all in one and direct drive  (thanks to this thingyverse project https://www.thingiverse.com/thing:4347673)


See pics below, I ran out of red for the last bit, hence printed in grey :)

As I have a spare stepper driver on the SKR 1.4 Turbo, now have each z axis motor on their own hence have enabled Z stepper Auto Align

Everything took much much longer than I anticipated (as usual) but pleased with the result :)

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version