Products > 3D printing

Need Help with Marlin 3D printer firmware

<< < (5/5)

thm_w:
Yeah these STM32 MCU are only going to be working with FAT or FAT32 as its a simpler file system to implement.

It should still show in windows if it is FAT32 or NTFS. In windows 10 you can right click on the start menu and go to Disk Management. Sometimes if there is an odd formatting the drive will not show the partition but should still be detected at the bottom. Could try reformatting/repartitioning it.

Alex_Baker:
I am familiar with disk management. The device shows up there when plugged in but it just says "no media", the same my empty cd drive says "no media" as you would expect.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod